I have reinstaled de ferduino code... only change the ethernet shield to true and the code of MyGLCD
Boolean_Stamps=false (i do not change this value)
just this changes
i´m waiting 2 minutes to view the result, but in 10 seconds its shows the new one if i had changed
1 conected gnd of relay to gnd of arduino
5v relay to 5v arduino
and the pin 42 to pin 1 of relay
pin 43 to pin 2 of relay
I will post the pictures of the boards and how i conect... maybe there´s something wrong
plug the ethernet making conecting pin 10 to pin 53
disconected pin 10, 11, 12 ,13
disconect pin 50, 51, 52, 53 of tft shield
make a bridge pin 4 to resistor R 16 and disconect one side of it
on this Picture you can see Heather and chiller turned off on the screen and on the relay board ... both of then ...on