Doubt about DHCP and IP [SOLVED]

[Romulo Gomes]

I do not understand network settings, and I use a modem with wi fi connection and a router to boost the wi fi signal on a homemade cable internet network. In this case I have to enable the DHCP command line?

Code: Select all

// Comment this line to use static IP.
// Comment this line to use static IP
// # define USE_DHCP // Uncheck this line to use DHCP

Another question, in these lines below do I have to change some configuration? Or do I keep everything as it is?

Code: Select all

#ifndef USE_ESP8266 //Do not change this line 
byte mac[] = {0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED }; // Este MAC deve ser único na sua rede local.
byte ip[] = {192, 168, 0, 177};                     // Configure o IP conforme a sua rede local.
IPAddress dnsServer(8, 8, 8, 8);                    // Configure o IP conforme a sua rede local. Este é o DNS do Google, geralmente não é necessário mudar.
IPAddress gateway(192, 168, 0, 1);                  // Configure o "Gateway" conforme a sua rede local.
IPAddress subnet(255, 255, 255, 0);                 // Configure a máscara de rede conforme a sua rede local.

Rômulo.

[Fernando Garcia]

There's nothing to change on code when using WiFi.

The meaning of this line:

Code: Select all

#ifndef USE_ESP8266

Is: If not defined USE_ESP8266

In others words if not using ESP8266 then...

You should set static IP in router settings.