Forum Members section DIY Ferduino controller Ethernet shield and module

Ethernet shield and module

Ask here about your controller made with pieces purchased in other shops.

Post Number:#1 Post Thu May 08, 2014 6:07 pm
Posts: 1699
Topics: 38
Images: 301
Solve rating: 233
Joined: Mon Mar 03, 2014 5:59 pm
Topics: 38
Age: 39
Location: São Paulo
Gender: Male
National Flag:
Brazil

To use an ethernet module with W5100 as this:

Image


You need to do the connection below:

Image


Check this topic to see how use the SD slot on TFT.

To use an ethernet shield with w5100, you need connect on this way:

Image


Notice that the pins 10, 11, 12 and 13 are not plugged.

To complete pins that are missing, you can make it:

Image


To prevent conflict between SD card from TFT and SD card on ethernet shield, you must remove pins 50, 51, 52 and 53 of the TFT shield.

Image


Image


Then make a bridge between R16 and pin 4 as shown in the image below.

Image
Post your doubts on forum because it can help another user too. Just PM me for support if it's absolutely necessary.



Return to DIY Ferduino controller





Who is online

Users viewing this topic: No registered users and 1 guest

cron